Week 1 : Introduction of electric and electronic:
- Basics of electric and electronic
- Electrical load and measuring device
- Electric Circuit Faults: Types and
- Fuses and Relays: Operation, Location, Circuits, and
- Battery: location, requirements, types, construction, rating capacity, tests, jump-start, and replacing.
Week 2 : Automotive electric and Diagnosis of Sensors:
- Charging & starting systems: types, components,
- Wires, connectors, wiring diagram with case
- DSO, OBD-II Scan tool, DTC with examples
- Sensors: speed & position (Inductive & Hall-effect), Load (MAP & MAF), O2, Knock, TPS & CTS & ATS & Fuel level sensor).
Week 3 : Computer Fundamentals& actuators:
- Computer Fundamentals: voltage sensing
- Ignition Systems: operation, types, signal
- Ignition Systems: operation, types, signal
- Injection Systems: operation, types, signal waveform, tests, fuel trim, case
- Injection Systems: operation, types, signal waveform, tests, fuel trim, case
Week 4 : Multiplexing Principles & Computer fundamentals
- EGR, Canister, IAC, ETC &
- PWM, ME-Motronic schematic diagram, Memory chips (RAM, ROM, EPROM, … ).
- Vehicle communications: CAN-Bus, FlexRay,
- Vehicle communications: examples, tests, case
Practical Training
- Training on multimeter usage
- Understanding device readings
- Practicing battery troubleshooting
- Reading sensor data
- Training on reading wiring diagrams
- Checking wiring harness continuity
- Identifying sensor locations
- Understanding device readings
- Understanding control unit signals
- Reading actuator data
- Wiring Diagram
- Identifying actuator locations
- Types of in-car networks
- Checking wiring harness continuity
- Troubleshooting with a diagnostic tool
- Understanding multimeter settings
- 3 days Managerial
Two months, 4 days a week, 3 hours per day.
- Egyptian nationality
- Automotive Engineering Graduate
- Age up to 35 years
- Determine the status of the army for male candidates
- Seriousness and commitment
- Passing the personal interview
